MachineTools.com: El mercado líder de la industria metalmecánica mundial

Chicago Dreis & Krump HSB-812 Hydraulic Powered Bending Brake:

SPECIFICATIONS:

Bending length: 97 inches 
Capacity (mild steel): 12 Gauge (.105")**
Capacity (stainless steel): 16 Gauge (.06")**
Approximate weight: 4000 pounds

** The bending capacity of the brake is achieved when using the angle bar in the high position and forming a 1inch minimum flange on capacity material.

STANDARD EQUIPMENT:
• Removable Nose Bar• Angle Bar
• Bolted Bottom Bar• 1” Insert Bar
• Compact Hydraulic Power Unit• Oil Level Sight Gauge

CONTROL PANEL FEATURES:
• On/Off Key Selector Switch• Motor Start Pushbutton
• Bending Leaf Up/Down Pushbuttons• Emergency Stop P/B
• Clamp/Unclamp Pushbuttons• Automatic Cycle P/B

ELECTRIC FOOT SWITCH – Clamps & Unclamps Top Leaf. Allows operator mobility when loading and unloading material.

BEND ANGLE DIAL ADJUSTMENT – Adjustable cam and scale that reads in degrees, actuates an electric limit switch for bend angle control and repeatability of bends.

MATERIAL THICKNESS DIAL ADJUSTMENT – Reference scale for speedier set up when adjusting clamping pressure.

BACK GAUGE – 25 ½ inch travel, rack & pinion type gauge with hand wheel adjustment on right side of machine. Inch/Cm. Scale.

INCH CONTROL – Bending leaf up/down pushbuttons allow complete operator control of the bending leaf motion.

AUTOMATIC CYCLE – Actuating the “Automatic Pushbutton”  clamps the top leaf, raises the bending leaf to the preset bend angle dial adjustment setting, lowers the bending leaf, unclamps the top leaf.





ELECTRICAL EQUIPMENT:

One 3 H.P. general purpose motor with direct mount hydraulic pump for operation on 220 or 440 volts, 3 Phase, 60 Hz with 110 volt control circuit (please specify voltage).
Canadian and special voltages including single phase available.

F.O.B.  Peotone, Illinois.  Shipping weight: 6,550 lbs.  

Shipped without Mobil DTE26 hydraulic oil.

Optional Electric powered Back Gauge with Digital Readout
Optional set of radius formers:  (Great for making gutters and mouldings)
Optional ¼ inch Insert Bar


For more information please feel free to contact us at:

American Machine Tools Corp.
5864 N Northwest Hwy
Chicago, IL 60631
773-334-5000 phone
773-442-0314 fax