TOYODA GL5A-63IIالمطاحن الأسطوانية بما في ذلك الرأس وسهل زاوية

Toyoda gl5
صور ( 3 )

الممزيد حول هذا النموذج

لعرض مزيد من المعلومات على TOYODA GL5A-63II ، بما في ذلك المعلومات التجارية، والصور، والفيديو، وأكثر من ذلك، انقر هنا .

الوصف

TOYODA GL5A-63II CNC ANGLEHEAD GRINDER, REFURBISHED

المواصفات

تحويل المواصفات للمتري
الأرجحة
12.9 "
المراكز
24.8 "
رأس عادية أو بزاوية
Angle Head
قطر عجلة التجليخ
24 "
قدرة العجلة
15 hp
غطس (نعم/لا
Yes
قياس (نعم/لا
Yes
دريسر (نعم/لا
Yes
CNC تحكم
CNC (GC32)

TOYODA GL5A-63II CNC ANGLEHEAD GRINDER, REFURBISHED

New 2002

Catalog Specifications:

12.6" Swing

24.8 " Distance Between Centers

24" Diameter x 12" Bore Grinding Wheel

Lateral Locating Gauge (Available)

In-Process Sizing Gauge (Available)

Tailstock

GC32 CNC Control

SCOPE OF REFURBISH:

Completely disassemble, clean, and inspect the machine components.

The table and wheel slide guide ways will be inspected for alignment. Turcite will be applied to way surfaces where required. If needed, the swivel table will be ground.

Re-establish centerline height between grinding wheel spindle, headstock, and footstock centers.

Refurbish Dead Spindle Workhead. Replace bearings, seals, and belts. Re-groove pulleys if required. Inspect servo motor, and make any required repairs.

Refurbish Footstock. Hone the housing, chrome and grind quill, fit at assembly. Replace bearings, seals, and scraper. Hydraulic cylinder will be repaired as required.

Refurbish Wheelhead. Inspect wheel spindle, bearings, and orifices. Clean spindle lube system, including reservoir, piping, etc. Replace spindle oil filter element. Replace drive belts. Repair or replace Wheelhead front way covers. Replace front rubber cover (over front way cover).

Refurbish Wheelhead Feed System. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Replace way wipers as needed.

Refurbish Table Feed. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Repair table way covers as needed. Replace rubber skirting. Replace way wipers as needed.

Refurbish Hydraulic/Lube System. Clean inside of reservoir. Clean and flush metal hydraulic lines and manifolds. Replace hydraulic hoses and tubing as required. Replace lube filter element.

Paint machine.

*** PHOTOS ARE OF A SIMILAR MACHINE WE COMPLETED ***

عن البائع

معلومات وجهة نظر الشركة