GIDDINGS & LEWIS 60 VTCعمودي مملة ميلز (incld VTL)

بطاقة الهوية
علامة تجارية
تستخدم - تمت إعادة تشكيلها
الولايات المتحدة الامريكية


This 60" G&L VTL is a KRC Machine Tool Services certified used machine tool. This machine has been completely disassembled and inspected. All mechanical assembles and been inspected and repaired to ensure the machine is in excellent mechanical condition. This machine has been CNC retrofitted with a new Fanuc 0i-TD control system, new Fanuc servo motors and drives and a complete machine rewire. New electrical documentation. KRC will provide a complete 1 year machine warranty. Mechanical ● Complete mechanical assembly & evaluation of the machine ● Clean & inspect ball screws and rail lifting screws ● Clean & Inspect table transmission & bearings ● Rebuild lubrication system ● Rebuild hydraulics system ● Inspect all wear material ● Install new way wipers ● Rebuild way covers ● Rebuild chip conveyor ● Full one-year warranty, parts and labor ● Paint machine Electrical ● All new electrical & electronics including a Fanuc 0i-TD CNC ● New Fanuc Alpha AC servomotors and drives ● Rebuild the existing 75HP Spindle Motor ● New NEMA 12 electrical magnetic panel enclosure ● New operators panel in a new pedestal mounted enclosure ● Complete rewire of the machine ● Complete documentation package ● Full one year warranty, parts and labor. Fanuc parts warranty - two years


تحويل المواصفات للمتري
قطر المنضدة
60 "
72 "
ارتفاع الشغل U/R
72 "
75 hp
200 rpm
CNC تحكم
CNC (Fanuc 0iT)


Model Giddings & Lewis 60” 2-Axis VBM
Fanuc or Siemens CNC Retrofit 2019
Automatic Tool Changer 12 Positions
Table size 60”
Maximum Swing 72”
Maximum Facing Capacity 72”
Maximum Height Under Rail 72”
Vertical Travel of Rail 48”
Vertical Ram Stroke 48”
Ram Travel, Z-Axis 48”
Ram Tool Holder Taper #60 ANS
Table Speeds: INF Variable 2 – 200 RPM
Table Speeds: 2 Ranges
Feed Rates (Variable) (.01 – 100 IPM)
Rapid Traverse, Rail Head X & Z-Axis 250 IPM
Rail Elevating Rate 30 IPM

*All machine specs are subject to verification
Equipped With:

Fanuc or Siemens CNC Retrofit
New Operators Station
12 Position Automatic Tool Changer
Power Draw Bar on Ram
60” 4-Jaw Manual Chuck

Ballscrews & Independent Servos
Way Covers
Chip Conveyor
Hardened & Ground Ways
75 HP Main Motor 460/3/60 Cycle

عن البائع

معلومات وجهة نظر الشركة