9” X 42” Capacity Vertical Milling Machine with 3HP Motor Variable Speed Drive (60-4500 RPM), R-8 Spindle, Meehanite Casting & Hard Chromed Ways
تحويل المواصفات للمتري
|مجال الحركة الطولية||30"|
|مجال الحركة القطعية||12"|
STANDARD EQUIPMENT: Hard-Chromed Ways Font & Rear Rubber Way Cover One Shot Lube System Variable Speed Head Tool Kit (includes: Machine manual, Half nut wrench, Wrench 17, & 19m, Set of 6 Allen wrenches, Phillip screwdriver, Flat head screwdriver, Oil can, Grease Gun, Rear way cover bracket, Pin for indicator Can of paint.) FEATURES: 3HP Motor Variable Speed Drive (60-4500 RPM) R-8 Spindle Meehanite Casting Chromed Ways Self-Lubricating Motor Shaft Extends Pulley Life Abec-7 Super Precision Spindle Bearings GENERAL SPECIFICATIONS: Table Working Surface: 9” x 42” T-Slots Number and Size: 3 Slots, 5/8” Travels (X, Y, And Z): 30” x 12” x 5” Ram Travel: 12” Knee Travel: 16” Spindle To Column (Min-Max): 6 3/4”-18 1/2” Spindle Nose To Table (Min-Max): 2 1/8”-18” Spindle Motor: 3 HP Spindle Nose Taper: R8 Spindle Variable Speed Drive: 60-4500 Rpm Quill Feed 3 Speed (IPR): 0.0015, .003, .006” Head Swivels: 360° Head Tilt (Lt. To Rt) : 45° Head Tilt (Up And Down): 45° Floor Area (W x D x H): 7’ x 6.5’ x 6.75’ Weight: 2,400 Lbs. Total Power Consumptions 220V: 3KVA/15 amps 440V: 3KVA/7.5 amps FEATURES, FUNCTION, & BENEFITS: ISO 9002 certified: Quality up to world industry standards.Meehanite casting: Highest grade of casting possible. A pair of precision ABEC-7 angular contact bearings to support spindle. The quill is ground and chromed to fit the housing: This insures a spindle run out of 0.0002” T.I.R. Motor shaft and VariDrive pulleys are dynamically balanced, then chromed for a flawless fit, ground ribs on inside diameter: For smooth speed changes. Motor shaft has an oil channel in the center that is fed by grease fitting on the lower end: To keep VariDrive pulley moving smoothly on the shaft. This LMV mill uses a roller bearing for the lower support of the shaft: It ensures proper loading, support and alignment. It also prevents the shaft from being distorted by the tension of the belt: For quiet, accurate operation at any speed for years and years. One shot lubrication system: For lubrication of ways and lead screws. (X, Y and Z-axis) Hand scraped saddle and knee: For better oil retention. It avoids having chips and dirt embed in the knee and damage the sliding surface. Oil groove are milled: For maximum lubrication on all wear areas. Table and saddle backlash is controlled by double nut design: Keeps lead screw in contact with bronze nuts all times to keep backlash at .0008” within 20”. Table and saddle are mounted with thrust bearings that are preloaded: Eliminating endplay for precisely controlled lateral movement. Ways are hard chromed dovetail on saddle and column.