Swing Over Bed Ways 36" Swing Over Cross Slide Carriage 32-3/4" Center Distance 141" Spindle Hole 12" Spindle Speeds 10 To 281 Rpm's Chuck Size 28" 4-Jaw New Gator Feeds Cross .0035 To .167 I.P.R. Feeds Long. .005 To .167 I.P.R. Threading Full Length 1 To 36 TPI Main Motor 75/37.5 Hp. 23' Long. X 92" Wide X 84" High Machine Height 89" Weight 26,000 Lbs. New Flange Holders 6 Power Wrench & Chuck Tool Post 4 Way On Front Yes Rapid Traverse Front And Rear Yes Cross Sliding Rear Turret Yes Coolant Note Reconditioning: Machine's front & rear aprons and rapid traverse box will be reconditioned. Rapid traverse drive box reconditioned, new bearings in main motor. New feed and rapid shafts. Headstock cleaned and flushed, new filters and oil. New lockdown pin and bushing in hex and square turret. New nut and screw in cross slide and hex turret. Gibs reworked and refitted. New 28" 4-jaw Gator chuck with reconditioning. It is recommended that you re-bore the flange tool holders on the rear turret to ensure they are on center once the machine is level. Machine wll be cleaned, painted, and cycled. Machine may be seen under power with proper notice.