12.6" x 59" Shigiya (Made in Japan) High-Precision     Universal I.D./O.D. Cylindrical Grinder   Model: GUA-32-150       S/N: 38221         New: 1986   Capacity Swing over table:                         12.6" Distance between centers:                 59" Max. grinding diameter:                   11"   Wheelhead Swivel range both right & left sides:     30 degrees each way Spindle speed:                            1,660 & 1,880 R.P.M. Max. Stroke (manual):                     8.66" Max. Stroke, (automatic):                 0.3" Rapid traverse stroke (hydraulic)         1..57" One revolution of handwheel:              0.05" One division of handwheel:                0.0001" Plunge cut infeed speed, inf. variable:   0.002" to 0.12" Traverse cut infeed speed, inf. variable: 0.00004" T0 0.004" Number of selectable grinding passes   before sparkout:                        0 to 30 Times Range of Spark out duration:              0 to 30 Seconds Grinding Wheel Size (OD x Width) x ID):   14" Dia.                                           1" to 2" Wide                                           5" Bore   Work Table Table stroke:                             65" Speed:                                    2 to 118 I.P.M. One revolution of handwheel:              0.787" Swivelling Range:                         7 Degrees CCW                                           1 Degree CW   Workhead Taper of Work Center:                     #4 Morse (7) Spindle Speeds:                       20 to 380 R.P.M. Swivel Range toward the grinding wheel:   90 Degrees Swivel Range toward the operator's side:  30 Degrees   Tailstock: Taper of work center:                     #4 Morse Quill Stroke:                             1.18"   Approx. Dimensions:                       146"L-R x 67"D X 60"H Approx. Weight:                           97000 Lbs.   Equipped With: Swing down I.D. Grindning attachement with I.D. grinding spindle Hydraulically actuated longitudinal table travel with   wheelhead fed at either each table reversal or with the   table stationary at the left or right hand side Automatic grinding cycle for plunge or traverse grinding   operations including hydraulically actuated wheelhead   rapid approach and retraction, coarse and fine grind   to pre-determined stop, and individual spark-out timers Universal motorized workhead with combinatation live/dead   spindle Tailstock Table swivelling angle measuring device (1) Grinding Wheel Mount (1) 2-point Steady Rest (1) Angular Wheel Dresser Magnetic Chuck 3-Jaw Chuck External coolant pump and tank, with Magnetic Separator 1 HP 3/60/230-460 volt external Hydraulic Pump Motor & Tank 5 HP 3/60/230-460 volt wheelhead drive motor Machine is presently wired for 220 volt operation   Special Note: This machine has been thoroughly serviced by our staff.  The machine has been  disassembled, partially repainted,  cycled and is ready for immediate delivery.   ** Superb Condition & Appearance ** ** Inspect Under Power in our Harrison, NJ Warehouse ** FOR MORE INFORMATION: Call Andy at 973-497-7600