KUSAKABE CBR

CBR is a cage roll forming method for ERW tube and Pipe that is manufacture under license from JFE Steel.the cage extends from the first break down to just before the first fin pass. The forming fl...

KUSAKABE CONVENTIONAL MILL

Convention forming mills are available to meet customers requirement from 8.0 by 0.6mm to 355 by 12.7 mm. Configuration out side this range are available on request. Standard and Sub Plate mounted ...

KUSAKABE DNC

KUSAKABE EXTERNAL WELD BEAD WINDER

Upon the removal of the weld bead the weld bead can be wound onto a bead winder. The coiled weld bead can then be automatically ejected into swarf bin.

KUSAKABE INTERNAL SWARF REMOVER

Swarf from internal fincutting is removed inline with the mill by using high pressure water.

KUSAKABE KEM COLD SAW

KUSAKABE KEM LEVELER

The uncoiler safely holds the coil of strip and enables the strip to be unstrapped and presented to the strip peeling and leveling equipment. For high productivity double sided uncoilers are used. ...

KUSAKABE KEM UNCOILER

The uncoiler safely holds the coil of strip and enables the strip to be unstrapped and presented to the strip peeling and leveling equipment. For high productivity double sided uncoilers are used. ...

KUSAKABE ROTARY SIZING MILL

The rotary sizing mill consists of two sets of rollers (cages) that are set at an angle to the tube to produce a cone. The tube is feed through the cone by the rollers and results in the reduction ...

KUSAKABE SHEAR AND END WELDER TIG MIG MAG

Shear and end welders crop the tail and nose of each coil. The two coil ends are then aligned and the joint welded using TIG, MIG or MAG depending on the material and thickness being welded. Single...