Mitsubishi 6 Axis CNC Gear Hobbing Machine Model # GC-40  S/N 41154C5 New sept. 1995 This Mitsubishi CNC Gear Hobbing machine can be inspected in excellent condition under power in our Statesville NC Plant. The machine was recently removed from a shop cutting the gears in the attached photograph. The machine is a very flexible Job Shop Machine. Machine specifications are as follows: PRINCIPAL SPECIFICATIONS:  Maximum work-piece diameter........................................16"/400mm  Maximum diametrical pitch/module.........................................(8M)  Maximum swiveling angle..................................................+45o  Minimum number of teeth....................................................5 Maximum number of teeth.................................................1000 Center distance Max/Min Hob spindle to work spindle..11.8"(300mm)/1.57"(40mm)  Maximum radial travel............................................10.6"(270mm)  Max. height work table to center of hob spindle..................23.6"(600mm)  Min. height work table center to hob spindle center...............7.9"(200mm)  Maximum axial travel.............................................15.7"(400mm)  Programming unit...............................................English (inch)  Distance between worktable and tailstock Max/Min....29.1"(740mm)/13.4"(340mm)  Worktable diameter...............................................11.8"(300mm)  Maximum worktable speed...............................................60 rpm  Maximum hob size.............................Diam 5.9"(150mm) x L 9.1"(230mm)  Maximum hob shift.................................................7.1"(180mm)  Hob speed range...................................................75-950 rpm  Feed rate:   Axial - inch/min. (mm/min.)........................... 0.04-39.4"(1-1,000mm)   Radial - inch/min. (mm/min.).......................... 0.04-39.4"(1-1,000mm)   Rapid traverse Axial - inch/min. (mm/min.)..................393.7"(10,000mm)   Radial - inch/min. (mm/min.)................................393.7"(10,000mm) Machine is equipped with the following Fanuc 16 MB CNC Controls Chip conveyor Hob arbor full guarding tailstock mist collector  Books and Manuals Call Rich Piselli to set up and under power inspection of this machine.