* SIEMENS Cycle Control, Model 805 Manual Turn for 2 axes. Direct input of all turning parameters via interactive operator interface. The appropriate software is available. Control Unit is built into a travelling chip protection door. * Hardened and ground guideways. Spindle/Chuck stops always on same position. * The carriage and the facing slide can be actuated for quick-feed by joystick in all 4 directions, but also with electronic handwheels for fine infeed. * The Mainspindle can be also controlled by a joystick forward and backward directions. * Built-on MULTIFIX Tool Holder Head Model CD with 6 different tool holders, * Separate swivable toolholder bloc to hold CAPTO – Tools with internal coolant supply and also To hold he regular MULTIFIX holders. Various CAPTO tools ara vailable inclusive collets. * Built-on 3-Jaw-Chuck Make SCA 300 mm Ø, separate Face Plate Ø 500 mm, 4-Jaw-Chuck 310 mm Ø, * Simple face plate 500 mm, and driver plate, various sets of jaws. * Two Protection doors one for the chuck area, other one is travelling with the carriage * Tailstock easily moved with air cushion, spindle length stop for inside mainspindle * Mobile chippan with coolant pump and oilskimmer, separate tool cabinet, working light, etc.

Height of centres 280 mm Max. swing Ø over guideways 570 mm Max. swing Ø over carriage/crossslide 365 mm Distance between centres 1.250 mm Spindle bore 62 mm Travel of face slide / upper slide 345 / 125 mm Spindle speeds, 2 steps, infinitely variable 3-500 / 15 – 2.500 rpm Longitudinal and facing feeds, infinitely variable 0.01 – 50 mm/rev Quick feeds, longitudinal / cross 5 / 10 m/min Feed capacity carriage, longitudinal, max. 6,5 resp.12,5 kN Max. weight of workpiece in chuck / between centres 400/1.000 kg Thread leads 0.1 – 400 mm Spindle drive 415/21kW * Total electrical load 25 kW - 400 V - 50 Hz Total Weight, approx. 4.000 kg