*Preliminary equipment descriptions are intended only as a guide, items of importance should be verified by the buyer-

CATALOG SPECIFICATIONS: MAXIMUM GRINDING DIAMETER .......................... 3" SWING OVER TABLE ................................... 5" CAPACITY BETWEEN CENTERS ........................... 12" MAXIMUM TABLE TRAVEL ............................... 13-3/4" TABLE SWIVELS EITHER WAY ........................... 10 DEGREES TABLE TRAVEL PER REV. OF HANDWHEEL ................. 0.44" HYDRAULIC TABLE TRAVERSE ........................... 0 TO 120" IPM DWELL (CARRIAGE) ................................... 0 TO 8 SECONDS WHEELHEAD (ALL GRADUATIONS, ON WORK DIAMETER): TOTAL TRAVEL BY FEED SCREW ......................... 3-7/8" HYDRAULIC RAPID RETRACTION ......................... 1-1/8" INFEED PER REV. OF HANDWHEEL ....................... 0.04" WHEEL FEED GRADUATION .............................. 0.0002" FINE FEED TO DEAD STOP ............................. 0.00005" INTERMITTENT INFEED, COARSE, MAXIMUM ............... 0.002" INTERMITTENT INFEED, FINE, MINIMUM ................. 0.00005" SPARKOUT ........................................... 0 TO 50 SECONDS WHEEL SPEEDS (2) ................................... 1830 & 1988 RPM GRINDING WHEEL ..................................... 12" X 1-1/2" X 5" MINIMUM WHEEL DIAMETER FOR ZERO WORK DIAMETER ...... 10" WORKHEAD: SPINDLE SPEEDS, INFINITELY VARIABLE ................ 50 TO 900 RPM CAPACITY THRU STANDARD DRAW TUBE ................... 3/4" MAXIMUM COLLET CAPACITY ............................ 3/4" APPROXIMATE WEIGHT ................................. 2,226 LBS MACHINE FEATURES HYDRAULIC TABLE TRAVERSE AUTOMATIC INFEED VARIABLE DWELL @ EACH END OF TABLE MOVEMENT AUTOMATIC HYDRAULIC RAPID ADVANCE AND RETRACTION OF GRINDING WHEELHEAD SPARKOUT TIMER (1 TO 50 SECONDS) AUTOMATIC CYCLE/MANUAL OPERATION SELECTOR INFINITELY VARIABLE WORKHEAD SPINDLE SPEEDS AUTOMATIC LUBRICATION FOR WHEELHEAD AND CARRIAGE WAYS SEPERATE ELECTRICAL CONSOLE CONTROL