Machine that consist of a continuous bending operation in which a long strip of sheet metal (typically coiled steel) is passed through sets of rolls mounted on consecutive stands, each set performing only an incremental part of the bend, until the desired cross-section profile is obtained.
very clean well maintained roll former
dreistern p915p-1815, 30 stand rafter type roll former
condition: very good
diameter of shafts 1-1/2"
roll space 12"
vertical adjustment 3 to 5-1/4"
top of base lower spindle 4-1/2"
motor 15 hp
w/roll tooling, for office partitions, driven roller stock guide/24 suction cup destacker, driven pre-punch system w/8 hydraulic punches, gear driven, allen bradley push button control panels, main motor
very clean and well maintained
dreistern 19 stand (side by side dual pass) roll former
number of stands 19
shaft size 25mm
roll space 5"
vertical adjustment 3" to 4"
base top to lower spindle 4-1/2"
horizontal center distance 5.5"
p60 type stands
bradbury 16 stand r panel rollform line
tooled for r & pbr panel
post cut air actuated cut off-4 post type
under power for inspection
approx 40' stacker not being used and stored outside
uncoiler-15,000 lbs capacity
dreistern p1216n-pe101, 14 stand roll former
condition: very good well maintained roll former
14 stand cantilever
number of stands 14
roll space 8-1/2"
distance between spindles centers 10"
top of base to lo...