A & G MERCURY 744AC
- SpecsConvert Specs to MetricCapacity4,000 lbWeight3760 (LBS)
- Product Overview
AC DRIVE MOTOR
Heavy duty Schabmuller Asynchronous Motor. The motor can either be supplied with a 36/48/80 Volt Depending on Model of Truck that is ordered. This motor has 26.80 hp (20 KW) and 291 ft-lb (390 Nm) of torque. This motor is rated at S2 for 60 Minutes (This is a European standard equivalent to USA standard Class H).
The Danaher AC MOSFET motor controller is the standard Inverter. The Danaher uses MOSFET technology with cold contactor switching, which will give extended battery, contactor tip and motor life which will give years of dependable service. Only a Line contactor and Pump Contactor are required, forward & reverse contactors are not required.
Foot operator accelerator and hand operated directional control.
The Model 700AC has headlights and stop/tail lights
as standard equipment which all run on 12 volt DC optimizing a DC-DC converter with isolated ground.
Hour meter, battery indicator, maintenance indicator all in one meter, key switch, and light switch.
Maintenance free axle offers a cutting edge design on technology. Designed as a rigid double planetary axle with an integrated motor. The G.A.W. rating is 17,160 lbs. (7,800 kg). Suspension has silent bushings on front for pivot mounting, and leaf spring in rear for smoother ride. This axle is supplied with a over all ratio of 20.16:1.
Fabricated solid beam type, and inclined king pins with needle bearings. Also equipped with a hydraulic cylinder for better steering control. With a 16” (406 mm) diameter steering wheel.
The drive axle has hydraulic wet disk brakes, sealed and oil lubricated.
The parking brake is integrated with the hydraulic wet disk brake on the drive axle, and is applied with hand lever.
The travel speed is adjustable from 0 to 10 mph (16.15 kmph) at 2190 rpm motor speed with a drive
axle ratio of 20.16:1. available upon request.
Higher travel speeds are
Front: 16.25” (413mm) x 6” (152mm) Solid Cushion.
Rear: 21” (533 mm) x 6” (152 mm) Solid Cushion.
- About Company
A & G Manufacturing Co., Inc. was founded by Arvin Shifley & Glen Shifley Sr. in 1971. We are still a family owned company today. We started out as a Job Shop facility with machining, welding, fabricating, and finish painting. In 1975 we built our first building which has had 5 expansions and is now called Plant 2. In 1993 we purchased what is now called Plant 1. In 1996 we purchased the Pettibone Mercury Tow Tractor line after fabricating and assembling the units for them for several years.