available with either a 43” wide frame or 60” wide frame
several charge box opening lengths
single side sheet construction
Meets all Current ANSI Z245.51 Safety Standards
Allen Bradley IEC components
EPAct TEFC Motors 460/3/60 – X Line Starting
Sequenced motor start-up with Economizer to shut down motors when not in use
Allen Bradley CompactLogix PLC
Panelview Touchscreen operator interface
Across-the-line conveyor motor starter (up to 10HP) and controls to optimize production
UL Approved NEMA 12 Electrical Enclosures
Operator controls mounted in MCC
Dual Infrared Cycle Control (Diffused)
Laser positioning
Pressure Transducer
Remote VPN Internet access
Left hand or right hand eject available
Manifold hydraulics with Regen
Hi-Lo vane pumps
Versa-Door w/transducer
Dual Infrared Cycle Control (Diffused)
Shimmable Serrated AR Shear Blade
Shear Beam Mounted at 9° Rake
Trunnion mounted main and eject cylinders
Full Main Ram Penetration
Hopper Access Door w/Safety Switch
Adjustable ram hold down bars
High/Low Floor
Replaceable Hardox 500 Floor and Ram Liner Strips alternating ½” to 1”
Replaceable ¼” Hardox 500 charge box side liners and press box side and top liners
Replaceable Hardox 500 Platen Strips
Bale table to support ejecting bale
Air-to-oil cooler
Tank Heater
Hot & Low Oil Shutdown
L & P Pinnacle II or Accent 470 Wire Tier
Dust Cover for Wire
1 – Stem of Galvanized Wire (11 or 12 Ga.)
Surface is painted with an industrial primer and 2 coats of industrial enamel.
Anchor clips
Optional 12.4 or 18.8 ton hydraulic stamper at shear
Four power unit sizes depending on the ram cycle time and hourly production required