Fully Automatic Tungsten Carbide Sawing Machine

THC-B101NC
1. Servo-motor drive + ball screw feed transmission
2. Sawhead driven by servo-motor + Ball screw transmission for cutting
3. Feeding safety guard (optional)
4. Fully feeding safety gurad (optional)

MODEL THC-B101NC
CUTTING CAPACITY TCT Carbide sawblade / HSS Sawblade
Round solid bar ●25 ~ 100 mm
Square solid bar ■25 ~ 76 mm
Rectangle ▃▃25 ~76 mm
Round pipe ○25 ~ 100 mm
Square pipe □25 ~ 76 mm
Maximum length of head cut 10 ~ 50 mm
Waste material length at tail end 85~(85+π Cutting length) mm
Feeding length 5 ~ 640 cycle feeding mm
Manually stack line-up loader capacity 3600 kg
Material length 3000 ~ 6000 mm
Material loading width 900 mm


TCT CARBIDE SAWBLADE Ø360 x 2.3 × t2.6 (t2.5~2.7) mm
Pin holes+Bore 4 × Ø14 × PCD80 & 4 × Ø11 × PCD63 x Ø32 / Ø40 / Ø50 mm
Tip aluminum carbide sawblade -- mm
Pin holes+Bore -- mm
HSS sawblade Ø360 x t2.5~3.5 4 × Ø11 × PCD63 x Ø32 / Ø40 / Ø50 mm
Spindle motor 11 (15HP) kw
Spindle speeds 12~120 rpm
Frequency inverter 15 (20HP) kw
Hydraulic pump motor 3.7 (5HP) kw
Operation pressure 7mpa 70kg／cm² mpa
Oil tank capacity About  150 ℓ
Air pressure 0.4~0.6mpa 4~6kg／cm² mpa
Feed drive AC servo-motor(1.8kw or 2.0kw) and precision ball screw
Sawhead drive A: Material feeding and cutting is driven by hydraulic system
B: AC Servo-motor(2.9kw or 3.5kw) + Precision ball screw transmission for cutting (Opt.)
Feeding vise Horizontal hydraulic type
Main vise Horizontal and vertical hydraulic type , one set each