TOYODA GL5A-63IIプレーン&アングルヘッドを含む円筒研削盤

ID:227548
ブランド:TOYODA
モデル:GL5A-63II
タイプ:プレーン&アングルヘッドを含む円筒研削盤
場所:Michigan
アメリカ合衆国
価格:

スペック

Lower:57
スイング:12.9 "
センター:24.8 "
プレイン または アングル ヘッド:Angle Head
砥石車 径:24 "
ホイール パワー:15 hp
Upper:77
プランジ (イエス/ノー):Yes
ゲージング (イエス/ノー):Yes
ドレッサー (イエス/ノー):Yes
管理:CNC (GC32)

TOYODA GL5A-63II CNC ANGLEHEAD GRINDER, REFURBISHED

New 2002

Catalog Specifications:

12.6" Swing

24.8 " Distance Between Centers

24" Diameter x 12" Bore Grinding Wheel

Lateral Locating Gauge (Available)

In-Process Sizing Gauge (Available)

Tailstock

GC32 CNC Control

SCOPE OF REFURBISH:

Completely disassemble, clean, and inspect the machine components.

The table and wheel slide guide ways will be inspected for alignment. Turcite will be applied to way surfaces where required. If needed, the swivel table will be ground.

Re-establish centerline height between grinding wheel spindle, headstock, and footstock centers.

Refurbish Dead Spindle Workhead. Replace bearings, seals, and belts. Re-groove pulleys if required. Inspect servo motor, and make any required repairs.

Refurbish Footstock. Hone the housing, chrome and grind quill, fit at assembly. Replace bearings, seals, and scraper. Hydraulic cylinder will be repaired as required.

Refurbish Wheelhead. Inspect wheel spindle, bearings, and orifices. Clean spindle lube system, including reservoir, piping, etc. Replace spindle oil filter element. Replace drive belts. Repair or replace Wheelhead front way covers. Replace front rubber cover (over front way cover).

Refurbish Wheelhead Feed System. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Replace way wipers as needed.

Refurbish Table Feed. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Repair table way covers as needed. Replace rubber skirting. Replace way wipers as needed.

Refurbish Hydraulic/Lube System. Clean inside of reservoir. Clean and flush metal hydraulic lines and manifolds. Replace hydraulic hoses and tubing as required. Replace lube filter element.

Paint machine.

*** PHOTOS ARE OF A SIMILAR MACHINE WE COMPLETED ***

詳細

TOYODA GL5A-63II CNC ANGLEHEAD GRINDER, REFURBISHED

このモデルの詳細

の詳細について表示するには、 TOYODA GL5A-63IIレビュー、ブランド情報、写真、ビデオ、および多くを含むが、 ここをクリック