REVOLUTION MACHINE TOOLS F-FAB 12-1ピンチ含むベンディングロールスロイス

ID:387754
ブランド:REVOLUTION MACHINE TOOLS
モデル:F-FAB 12-1
タイプ:ピンチ含むベンディングロールスロイス
条件:新しい在庫がある
年:2016
売り主:販売者が誰であるかを見せて...
場所:Bursa
トルコ
価格:

スペック

Lower:77
ロール 長さ:3.7 m
(Init/Dbl ピンチ または ピラミッド):MULTIPLE
最大 厚さ:1.628 mm
最大 厚さ (ゲージの):14 ga
ロール数:3
HYD /メカ:Mech
Upper:97
パワー リアー ロール (イエス/ノー):Yes
パワー:3 kW
ロール径:25.4 mm
大きさ:HxLxW= 85"x200"x26"
重量:~ 7500 Lbs

FARNHAM STYLE
12’x0.0641" capacity.
1" top roll, 1-11/16" bottom rolls,
All rolls driven by 2-Speed motors,
220V / 3 Phase / 60 Hz,

Digital readout for upper beam,

TOP ROLL LIFT MOTORS
Geared motor to screw located on each end.
Digital readout for each end of Top Roll
Each motor with Mechanical Brake

BOTTOM ROLLS:
Each with In/Out Adjustment and Indicators located on both end.
TIE ROD BED ADJUSTMENT to put slight bow in bed.

CONTROLS:
Roll Drive Motor Start/Stop Buttons.
Two Roll Speed in Forward/ one Roll Speed in Reverse.
TOP ROLL Up/Down buttons to adjust BOTH END elevation screws at same time.
TOP ROLL Up/Down buttons to independently adjust EACH END elevation screws.
Safety Stop located on front and rear.

詳細

3-ROLLS FUSELAGE PANELS AND WING EDGE BENDING MACHINE (FARNHAM STYLE)

For the aviation industry fastest, easiest and precise bendings are only can be made by RMT F-FAB series machines. This machine bend the aluminium or titanium alloyed sheets by many points for bending to get precise cylindrical or conical bending forms. Aluminium or titanium alloyed plates spring back is too much and these kind of sheets thicknesses are thin, yield strength is high and elastic module is low. For this reason these sheets can only bend by RMT F-FAB series machines and there is no possibility to bend with traditional 3 roll & 4 roll Plate Roll bending machines. Plate Roll bending machines rolls diameters are too big and no possibility for aluminium or titanium alloyed plates bendings.

ダウンロード

このモデルの詳細

の詳細について表示するには、 REVOLUTION MACHINE TOOLS F-FAB 12-1レビュー、ブランド情報、写真、ビデオ、および多くを含むが、 ここをクリック