Acer ATL-1440E 14"Swing Flat Bed CNC Teach Lathe W/Fagor 8055 i/A-TC Control Make: Acer Model: ATL-1440E Controls: Fagor 8055 i/A-TC Swing Over Bed: 14" Swing Over Cross Slide: 8-3/4" Swing Over Saddle Wings: 14.17" Height Of Centers: 7" Distance Between Centers: 39.37" Spindle Nose: D1-4 Or A1-5 Spindle Taper: MT#5 Spindle Dia At Front Bearing: 2.77" Spindle Through Hole: 1-9/16" Taper In Reduction Sleeve: MT#3 Number Of Spindle Bearing: 2 Number Of Speed Range: 2 Spindle Speed Range Rpm: 60-650/300-2700 Cross Slide Travel: 7.87" Compound Rest Travel" 3.94" Tool Section Max: 3/4" X 3/4" Bed Length: 54" Width Of Bed: 9" Height Of Bed: 10.63" Slideway Surface Hardness: HRC 48 Quill Outer Diameter: 1-9/16" Quill Travel: 4" Taper Of Center: MT#3 Max Rapid Feed Z (IPM) 400 Ipm Max Rapid Feed X (IPM) 400 Ipm Spindle Motor Brake W/Servo Motor Splash Lube Headstock Lubrication Coolant Tank Capacity: 5.78 Gal 1/8 Hp Coolant Pump Motor 5 Hp Spindle Motor/ 7.5 Hp (30 Min) Power Requirements: 230/460V 3Ph Standard Accessories: 5HP Servo Drive Spindle Motor High-Low Speed Range Selection Canned Cycles Semi-enclosure Splash Guard Coolant System Tailstock Dead Centers Leveling Pads with Screws Tool Box with tools Operational Manual Dual Manual Pulse Generator Halogen Light Optional Accessories: 6” 3 Jaw Chuck 8”/10” 4 Jaw Chuck Roller Follow Rest Roller Steady Rest Faceplate: 10”, 12” 5C Collet Closer Quick Change Tool Post Remote Stop/Go Switch (Must be installed at factory!) Electric 4 Way Tool Post (Must be installed at factory!) Full Enclosure Splash Guard (Must be installed at factory!)