TOYODA GL5A-63II CNC ANGLEHEAD GRINDER, REFURBISHED
24.8 " Distance Between Centers
24" Diameter x 12" Bore Grinding Wheel
Lateral Locating Gauge (Available)
In-Process Sizing Gauge (Available)
GC32 CNC Control
SCOPE OF REFURBISH:
Completely disassemble, clean, and inspect the machine components.
The table and wheel slide guide ways will be inspected for alignment. Turcite will be applied to way surfaces where required. If needed, the swivel table will be ground.
Re-establish centerline height between grinding wheel spindle, headstock, and footstock centers.
Refurbish Dead Spindle Workhead. Replace bearings, seals, and belts. Re-groove pulleys if required. Inspect servo motor, and make any required repairs.
Refurbish Footstock. Hone the housing, chrome and grind quill, fit at assembly. Replace bearings, seals, and scraper. Hydraulic cylinder will be repaired as required.
Refurbish Wheelhead. Inspect wheel spindle, bearings, and orifices. Clean spindle lube system, including reservoir, piping, etc. Replace spindle oil filter element. Replace drive belts. Repair or replace Wheelhead front way covers. Replace front rubber cover (over front way cover).
Refurbish Wheelhead Feed System. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Replace way wipers as needed.
Refurbish Table Feed. Inspect ballscrew, support bearings, servo motor, and coupling, make any required repair/replacement. Repair table way covers as needed. Replace rubber skirting. Replace way wipers as needed.
Refurbish Hydraulic/Lube System. Clean inside of reservoir. Clean and flush metal hydraulic lines and manifolds. Replace hydraulic hoses and tubing as required. Replace lube filter element.
*** PHOTOS ARE OF A SIMILAR MACHINE WE COMPLETED ***
이 모델에 대해 더욱더많은 정보를 보기 위해서는 TOYODA GL5A-63II, 리뷰포함, 브랜드 정보, 사진, 비디오 등, 여기를 클릭하세요..