Maximum Weight Of Coil: 50,000 Lb.
Maximum Material Width: 72"
Drum Face: 79.75"
Maximum Dia. Of Coil: 72"
Dia. of Drum Collapsed: 19.5"
Dia. of Drum Expanded: 20"
Motor Hp: 150 Hp D.C.
Internal Gearbox Ratio: 8:1
Floor to Center of Drum: 65"
Line Direction: Right To Left
Overarm Holddown Roll
Hydraulic Clamping of Material
Hydraulic Expanding of Drum
Hydraulic Sliding Base
The Housing is a heavy duty fabrication to support the Mandrel, Drive, Pushoff, and Overarm Separator. The Unit is precision
machined to assure alignment of all units.
The Main Shaft is made of pre-hardened alloy
The Drum is fabricated from alloy steel with a
hardened surface on the Gripper Segment to
prevent marking on Pushoff.
A Wedge Type Gripper assures gripping of
heaviest and lightest gauges.
The Dual Direction Gripper allows for over or
under wrapping of coils.
Drum Expansion is by wedges thru a hydraulic cylinder which also clamps the material. The design of the Gripper area minimizes humping
of material, preventing out of roundness.
The Pushoff is a heavy plate supported by two
guide rods with bushings in the housing. A Hydraulic Cylinder pushes the material
off the mandrel.
Overarm Holddown Roll: Cantilever Mount
The Overarm Hold Down is cantilever mounted on the Recoiler. A limit switch is provided to prohibit the actuation of the pushoff with the
arm down. The Holddown Arm is operated by an air cylinder.
The Recoiler Housing is supported on hardened wear plates on the machined ways of a fabricated steel Sub-Base. A Hydraulic Cylinder mounted in the Sub-Base will shift the Recoiler either side of centerline as required for coil alignment.
Base (Floor) Plate Is 77.5" L-R x 68" F-B.
Integral Gear Reducer:
The Internal Reducer has Herringbone Gears and a reduction ratio of 8:1. Rated Input Horsepower is 150.
Delivery: In Stock; Toledo, Ohio
Note: Price is less Dc Motor and Drive.
(Can be provided at extra cost)