모델:PATRIOT 551
형태:잡지 형 바 로더
판매자:판매자가 누군지보기 ...
Stock # :340873


General Specifications per Manufacturer

Bar Capacity:
No Prep: 5mm to 44.5mm (.196" to 1.75")
With Prep: 5mm to 51 mm (.196" to 2.000")
Maximum Bar Length: 12'6"
Minimum Bar Length: 39.4"
Maximum Remnant Length: 16"
Magazine Rack Capacity: 12"
Bar Loading Cycle: 30 seconds for 12' bar
Material Straightness Specifications: .007"TIR/ft of material
(V Blocks, 3 points equidistant)
Feed Force (pusher torque): max 450N, adjustable
Foward Feed Rate: 750 inches/min max, adjustable
Return Feed Rate: 1000 inches/min max, adjustable
Power Consumption: 1.5kW
Operating Voltage: 230V/60 Hz - 3 phase
Control Voltage: 24V DC
Oil Capacity: 57 liters (15 gallons)
Oil Viscosity: ISO 150cST
Compressed Air Supply: 6 bar (90 psi)
Compressed Air Consumption: approx. 8 liters/loading cycle
Weight (approx): 2,100 lbs
Dimensions (approx.): 16' x 2' x 4.25'

(1) Guide channel set of your choice (channel sections, pusher & revolving
(1) Front nose to match guide channel
(1) Barstock collet
(1) Outboard anti-vibration device bushing
(1) Custom lathe cable & interface plug

Patriot 551 12' 2 Guide Channel Set Complete Package
Includes (2) channel sets, (2) pushers, (2) Hard noses, (2) Pusher Collets,

(2) Sets of Bushing Blocks: $32,795.00

Patriot 551 8': $27,500.00

Patriot 551 8' 2 Guide Channel Set Complete Package
Includes (2) Channel Sets, (2) Pushers, (2) Hard Noses, (2) Pusher Collets and

(2) Sets of Bushing Blocks: $30,300.00

Optional Accessories - Prices subject to change without notice:
Installation: $3100.00

Additional Guide Channel Set: $3250.00
(includes pusher, revolving tip, nose liner & spindler liner)
Spindle Liner: $ 420.00
(needed when selecting a guide channel set other than lathes max. cap. set)

Bar Stock Pusher Collets:
Up to 38mm: $125.00 each
39 - 51mm: $175.00 each
Front Ejection Pusher collet: $350.00 each

Bushing Blocks for outboard Anti-Vibration device
(1) set includes upper & lower pieces: $120.00 each

High Voltage Kit (required for some lathes):$1,500.00

Bar Feeder installation does not include lathe-side software or hardware
interface. This interface must be supplied and installed by the lathe
OEM or dealer prior to bar feeder installation.

The anchoring of the FMB bar feeder to the floor is a requirement and will be
performed by the service technician.

Barfeed on pallet: 181" x 29" x 64" 2,500 lbs


Edge Patriot 551, 0.196 - 2" x 12', for Fixed or Sliding Headstock, NEW

이 모델에 대해 더욱

더많은 정보를 보기 위해서는 EDGE TECHNOLOGIES PATRIOT 551, 리뷰포함, 브랜드 정보, 사진, 비디오 등, 여기를 클릭하세요..