Travels: 41.3” x 21.7” x 22”
Table size: 55” x 21.7”
Pallet size: 40” x 19” each
Max/min distance spindle nose to table: 7.9 ‘ to 29.9”
Spindle taper: BT 50
Spindle speeds: 40 to 4,000 rpm
Max. weight on table: 3,300#
Spindle center to column: 23.6”
Spindle HP: 15/10 HP
Rapid feed rates: X & Y & Z: 590 IPM on X & Y, 472 IPM on Z
Cutting feed rates: 1 to 197 ipm
ATC: 30 place
Wired: 220V/3ph/60 cy
Weight: Approximately 22,000#
Dimensions: (Floor space) 140” x 143” x 119.5” (shipping height: 107.1”)
Mori MF-M6 controls (Fanuc 16M) with recent new CRT and Video Module
Extra Offsets, Macros
4th axis drive installed (at one time they were using a Tsudakoma rotary)
DIN Coolant thru tool with 2) BT 50 Speed Inducer Tool holders
Approximately (60) total BT 50 tool holders
Coolant system with 66 gallon capacity
Chip removal Paddles at rear of table
Full enclosures with full covers
Front doors interlock system
Side door for tool insertions has door interlock
Heavy duty Linear ways on X & Y axis with 45 mm diameter ball screws
Midaco Md. 40SD dual pallet changer with Auto Door separation and (2) 40” x 19” pallets
Mori Seiki: 2) Electrical
SN: 1975, New 1995 (I think, it might be newer)
Condition is Excellent!
The only reason it was sold was to make room for a 50” travel in X, VMC.
Special note: This is not your typical VMC with Pallet changer; you can use it without any pallets because it still is basically a factory standard VMC with its own table. Not one with a dedicated APC and no table with just pallets.
Specifications are approximate, intended solely as a guide and are not binding. It is the buyers’ responsibility to inspect the goods and ascertain if the specifications, description, and condition of the goods conform to the buyers’ requirements.