The machine for sale is an Advanced Cutting Systems 60" x 120" table with a Koike controller. The power supply is a Hypertherm 1650 (100 amp) with a Hypertherm Sensor PHC torch height controller. The machine will pierce up to 3/4" steel and edge cut 1" plate. The machine was performing perfectly when we replaced it with a new larger CNC plasma table on May 9, 2016.
Also included one 71/2 hp and one 5 hp air compressor with refrigerant type air drier all mounted on a skid.
Nesting software, along with ductwork software is included.
A new spare bridge drive servo, a new Hypertherm PHC torch height controller and some consumables are included.
This is a turn key package minus a computer to install and run the nesting software.
Freight is buyers responsibility.