REVOLUTION MACHINE TOOLS F-FAB 12-1핀치 등의 플레이트 벤딩 롤

ID#:387754
상표:REVOLUTION MACHINE TOOLS
모델:F-FAB 12-1
형태:핀치 등의 플레이트 벤딩 롤
조건:새로운에서 주식
년도:2016
판매자:판매자가 누군지보기 ...
위치:Bursa
터키
가격:

투기

Lower:77
롤 길이:3.7 m
(초기화 / 더블 핀치 또는 피라미드):MULTIPLE
최대 두께:1.628 mm
최대 두께(게이지):14 ga
#롤:3
유압/기계식:Mech
Upper:97
파워 후면 롤:Yes
동력:3 kW
롤 직경:25.4 mm
치수:HxLxW= 85"x200"x26"
무게:~ 7500 Lbs

FARNHAM STYLE
12’x0.0641" capacity.
1" top roll, 1-11/16" bottom rolls,
All rolls driven by 2-Speed motors,
220V / 3 Phase / 60 Hz,

Digital readout for upper beam,

TOP ROLL LIFT MOTORS
Geared motor to screw located on each end.
Digital readout for each end of Top Roll
Each motor with Mechanical Brake

BOTTOM ROLLS:
Each with In/Out Adjustment and Indicators located on both end.
TIE ROD BED ADJUSTMENT to put slight bow in bed.

CONTROLS:
Roll Drive Motor Start/Stop Buttons.
Two Roll Speed in Forward/ one Roll Speed in Reverse.
TOP ROLL Up/Down buttons to adjust BOTH END elevation screws at same time.
TOP ROLL Up/Down buttons to independently adjust EACH END elevation screws.
Safety Stop located on front and rear.

세부내역

3-ROLLS FUSELAGE PANELS AND WING EDGE BENDING MACHINE (FARNHAM STYLE)

For the aviation industry fastest, easiest and precise bendings are only can be made by RMT F-FAB series machines. This machine bend the aluminium or titanium alloyed sheets by many points for bending to get precise cylindrical or conical bending forms. Aluminium or titanium alloyed plates spring back is too much and these kind of sheets thicknesses are thin, yield strength is high and elastic module is low. For this reason these sheets can only bend by RMT F-FAB series machines and there is no possibility to bend with traditional 3 roll & 4 roll Plate Roll bending machines. Plate Roll bending machines rolls diameters are too big and no possibility for aluminium or titanium alloyed plates bendings.

다운로드

REVOLUTION MACHINE TOOLS F-FAB 12-1 (828키로 바이트)
파일을 다운 받기 위해서는 여기를 누르십시요

이 모델에 대해 더욱

더많은 정보를 보기 위해서는 REVOLUTION MACHINE TOOLS F-FAB 12-1, 리뷰포함, 브랜드 정보, 사진, 비디오 등, 여기를 클릭하세요..