BULLARD CUTMASTER 54수직 보링 밀스 (incld의 VTL)

세부내역

54" Used Bullard Cut Master Vertical Turret Lathe Ref.#B600652 Model: Cutmaster Serial No. New: 1955 Table Size...54" 4 Jaw Swing Side Head Above Table...58" Swing Side Head Below Table...62" Height Under Rail...42" Rail Travel Vertical...36" Table Speed...4.4 To 160 Rpm's Feeds....0026 To .500 Main Motor...40 Hp. 220/440 Turret Head Horizontal Travel...34-3/8" Turret Head Vertical Travel...30-1/2" Turret Head Position...5 Turret Head Swivel...30 Degrees L Or R Side Head Travel Vertical...44-1/4" Side Head Travel Horizontal...27" Ram Head Swivel Right & Left Of Center...30 Degrees Ram Head Travel In & Out...34-3/8" Ram Head Travel Up & Down...30-1/2" Machine Weight...44,000 Lbs. Over All Dimension Right To Left...154" Over All Dimension Height...124" Over All Dimension Front To Back...116' Pendant Control...Yes Rapid Traverse On All Heads...Yes Note: Requires A Small Pit For Bearing Nut. Note: Machine Has Been Removed From Service. Machine Will Be Cleaned, Painted And Cycled. All Feed And Rapid Shafts Seals Have Been Replaced. Hand Wheel Seals Have Been Replaced, Gear Boxes Have Been Cleaned And Checked. Hydraulics And Main Motor Have Been Reconditioned. Condition: Good

투기

미터에 사양 변환
테이블 직경
54 "
스윙
64 "
작업 높이-레일 하단
44 "
동력
40 hp
분당 회전속도
160 rpm
치수
154" X 116" X 124"
무게
45,000 Lbs.

54" Used Bullard Cut Master Vertical Turret Lathe Ref.#B600652
Model: Cutmaster
Serial No. New: 1955

Table Size...54" 4 Jaw
Swing Side Head Above Table...58"
Swing Side Head Below Table...62"
Height Under Rail...42"
Rail Travel Vertical...36"
Table Speed...4.4 To 160 Rpm's
Feeds....0026 To .500
Main Motor...40 Hp. 220/440
Turret Head Horizontal Travel...34-3/8"
Turret Head Vertical Travel...30-1/2"
Turret Head Position...5
Turret Head Swivel...30 Degrees L Or R
Side Head Travel Vertical...44-1/4"
Side Head Travel Horizontal...27"
Ram Head Swivel Right & Left Of Center...30 Degrees
Ram Head Travel In & Out...34-3/8"
Ram Head Travel Up & Down...30-1/2"
Machine Weight...44,000 Lbs.
Over All Dimension Right To Left...154"
Over All Dimension Height...124"
Over All Dimension Front To Back...116'
Pendant Control...Yes
Rapid Traverse On Both Head...Yes

Note: Requires A Small Pit For Bearing Nut.

Note: Machine Has Been Removed From Service.
Machine Will Be Cleaned, Painted And Cycled. All Feed And Rapid Shafts Seals Have Been Replaced. Hand Wheel Seals Have Been Replaced, Gear Boxes Have Been Cleaned And Checked. Hydraulics And Main Motor Have Been Reconditioned.
Condition: Good

판매자에 대해

보기 회사 정보