CANTEK GT760ARD

  • Spec
    Metrik Özellikleri dönüştürme
    Azami Planlama Genişliği
    30 "
    Güç
    25 hp
  • Ürüne Genel Bakış

    FEATURES
    Heavy duty cast-iron machine body and table for vibration-free running
    Cutterheads are spiral insert type with six (6) rows of carbide inserts. These cutterheads produce an excellent finish, run much quieter than conventional straight knife heads, and require less HP to perform the planing operation. The inserts are an industry standard item, and have two (2) cutting edges.
    Conveyor feed system uses a spring loaded pin arrangement to pass material over the bottom jointing head. A driven rubber top roll, after the top head, delivers the material out of the machine
    Variable feed speed by frequency inverter
    Infeed bed roller – idle
    4 Bottom full width bed rolls greatly assist in feeding material
    Digital electronic thickness adjustment in INCH and MM. Inch is to 3-deicimal places
    Opening of the machine is motorized, and driven by a 1/2HP TEFC motor
    Swiveling control panel for more ergonomic access to machine controls (Not shown)
    Easy to access external handwheel adjustment of infeed bed
    The Table surface is hard chrome plated and precision ground for smooth performance and maximum wear resistance at high speeds
    A hand lubricator is provided for convenient lubrication to the table slideways and an auto lubricator provides lubrication to the caterpillar feed chain
    Chipbreaker and top feed roller into top head is sectional
    Rubber outfeed top roller to prevent chip marking
    Over thickness safety shut-off bar across infeed.
    Ammeter for each motor on control panel to monitor motor load
    Side covers to protect operator around bottom head
    Star Delta soft start
    Isolator switch to shut off power to control panel for added safety.
    Electrics are 230/460 or 460/3/60 to UL/CSA Standards (other voltages on request)

  • Şirket hakkında

Yeni satın almak isteyen CANTEK GT760ARD ?

Distribütörler